PA66 GF30 kunststofdeel voor cameralens

This is a PA66 GF30 plastic part used for the camera lens. This part requires tight tolerance which includes the flatness, roundness, and precise part weight.

Onderdeelspecificatie

Materiaal	PA66 GF30
Grootte (mm)	OD 42 x width 15 mm
Weight (gram)	18 grams
Tolerance for key dimension (mm)	+/-0,05 mm
Processes	Spuitgieten

10% lot inspection or 100% inspection depending on the inspection results
We do a 10% dimensional lot inspection, a go-no go gauge to make sure all key dimensions meet the tolerances, if any dimension fails then a 100% inspection will follow to make sure no bad parts will be shipped.

PA66 GF30 kunststofdeel voor cameralens

PA66 GF30 kunststofdeel voor cameralens

Onderdeelspecificatie

10% lot inspection or 100% inspection depending on the inspection results We do a 10% dimensional lot inspection, a go-no go gauge to make sure all key dimensions meet the tolerances, if any dimension fails then a 100% inspection will follow to make sure no bad parts will be shipped.

Verwante producten

Een kunststof cilindercontainer voor wandzeepautomaat

Kunststof mal voor LED fitting

TPU injection molding of a mobile phone side skirt

Simple plastic end cap with low mold cost

Boyan Productie-oplossingen Limited

10% lot inspection or 100% inspection depending on the inspection results
We do a 10% dimensional lot inspection, a go-no go gauge to make sure all key dimensions meet the tolerances, if any dimension fails then a 100% inspection will follow to make sure no bad parts will be shipped.